The following procedures are examples of low water pressure evolutions based on the procedures of the Moraga-Orinda Fire District, presented for illustrative purposes.

1. Remove the Floto Pump and wye set (double gated wye on a short pigtail.)

2. Attach the pigtail to the pump.

3. Open the fuel tank vent and set the choke.

4. Pull the starter rope until the pump fires. Open the choke and start the pump.

5. Let the pump idle for a few seconds before placing it in the water.

6. Carefully slide the pump into the opening of the tank.

   Key Point:

   When handling the pump, and especially when removing it from the tank, take note of the muffler location and avoid contacting it!

Lay everything out first

Fuel vent & choke are on the same side

Sliding the pump into place

Checking the balance of the floating pump